SK78 Dynamica 4mm to 36mm X The Metre
Standard shipping
Estimated delivery time: 2-3 days
12 Strand Dynamica / Dyneema SK78 Ropes 4mm to 36mm
Genuine Dynamica SK78 Dyneema Rope. Dynamica SK78 Rope 4mm 5mm 6mm 8mm 10mm 12mm INSTORE FOR PICKUP
14mm 16mm 18mm to 36mm SENT FROM THE SUPPLIER
Genuine Dyneema is the world's strongest fibre, with excellent properties.
Sizes range from 4mm to 36mm in Diameter.
Dynamica ropes are manufactured from Dyneema fibres produced by DSM in Holland
Applications:
- 4 x 4 Outdoors Winches.
- Offshore Applications
- Fisheries
- Bridles, Gilson’s, Cod lines,
- Headlines, Selvage Ropes,
- Front End Meshes, Warps
- Lifting Applications
- Mooring Ropes
- Towing
DYNAMICA ropes are produced from Dyneema fibres type SK78. Tension-tension fatigue Dyneema fibres can sustain many peak loads (loads close to the breaking strength).
This gives long life and a high safe working load. While steel wire can take 6500 loads at 50 % of the maximum breaking load, DYNAMICA ropes can take 10 million cycles at the same load level. DYNAMICA ropes are, therefore, an excellent material for dynamic applications.
Safety Dyneema fibres have a very low elongation (2-3% at break). It stores little energy and therefore has little backlash - even at hundreds of tonnes of load.
Using Dyneema fibres, the amount of stored energy is much lower vis á vis nylon or steel wire ropes. This is a very important safety feature. Dyneema fibres are UV-stable and have better stability in sunlight than other relevant fibres.
After two years of exposure, 80% of the strength is retained. Dyneema fibres are resistant to chemical substances and will not be affected by oil, acids, or other substances.
Abrasion Dyneema fibres have excellent abrasion resistance compared with other synthetic fibres (five times better than polyester).
However, special care must be taken to ensure that it moves over clean non-rust surfaces, etc. Sharp edges etc., should be avoided. Bending-bending fatigue Dyneema fibres have good bending properties.
However, it is recommended to bend over diameters of at least five times the diameter of the rope.