Aluminium Mini Single Sleeve Crimp – 0.70mm Capacity (Pack of 1000)

Tailored for precise termination of fine-gauge conductors, this aluminium mini single sleeve crimp provides consistent radial compression across 0.70mm² wire cross-sections.

The compact insulated barrel clears tight chassis routing paths and dense panel mounts where standard terminals create excessive bulk. Constructed from annealed aluminium alloy, each sleeve deforms evenly under manual crimping pressure, displacing surface oxides to establish stable contact resistance while shielding joints from moisture ingress and vibration fatigue.

Technical Specifications

• Barrel Construction: Roll-formed aluminium alloy
• Rated Cross-Section: 0.70mm² nominal
• Sleeve Design: Polymer-insulated single barrel with open termination end
• Quantity: 1,000 pieces per package

This engineering series supports standardized cross-sections spanning 0.80mm² through 1.50mm². To maximize mechanical retention and prevent conductor nicking during installation, technicians should select a sleeve approximately one size larger than the target wire line. This sizing protocol guarantees full die engagement without compromising strand integrity.

Optimized for custom trace assemblies, low-voltage harnessing, automotive lighting circuits, and PCB-to-terminal block bridging, these crimps eliminate splice variability and streamline high-density wiring projects. The geometrically uniform profile accepts standard diagonal and ratcheting hand-crimpers for repeatable joint consistency across assembly lines.